SPECIFICATIONS

MODEL 2000 - FOR BOATS

Rated for 2,000 lbs. total boat, motor, fuel and gear.
Use on any sloped shoreline up to 20-30% grade depending on the weight of your boat.
Roller configuration fits all hull designs.
All aluminum and stainless steel construction assures long life.
Modular Design allows for portability (Remove 4 bolts to separate each 8 1/2 ft. section)
Use where in-water docks and lifts are not allowed, practical or too expensive.
Max. weight capacity - 2,000Lbs; Weight - 130Lbs; Overall Length - 17'2"; Overall Width - 36"; Roller Spacing - 25" side to side and 24" front to back for 5 sets, last set at 6" from end; Roller type - Adjustable Ribbed 4" wide Polyolefin; Number of Rollers - 24; "Rocking" Delrin Sleeve Bearing; Tilting Roller Axle; Aluminum construction with Stainless Steel hardware; Shelby Zinc Plated Winch with Dead Lift rating of 1,700Lbs,5:1 Gear Ratio, 25' Strap and Hook with Standard Boat Hook; Screw-in Ground Anchor with hardware; Min. Required Anchoring - Screw-in or Fasten to Wall or Footing.

These shore ramps can be used on virtually any surface without risk to your hull.

Easy to use. Just hook, crank it and lock it with a standard bicycle lock.

Can be used on gradual sloped shoreline.

Comes with standard 5:1 ratio winch. Upgrade available to 2-speed winch with hand operated brake. Both winches include a 25' nylon strap and hook.

Ground anchoring kit included with Model 2000. Click Here to Order Roll-n-Go